Mother
Specifications
Processor/Cache
CPU
• Dual 1366-pin LGA Sockets
• Supports up to two Intel® 64-bit Xeon®
processor(s) of the same type below:
• Dual
Intel® 5600 series Xeon® Quad/ Dual-Core
Processor
• NOTE: Support processors with Max TDP
< 100W
QPI
•
Up
to 6.4 GT/s
System Memory
Memory Capacity
• 12x 240-pin DIMM sockets
• Supports up to 192 GB• • 1333 / 1066
/ 800MHz DDR3 ECC Registered memory
• Supports up to 24 GB 1333 /
1066 / 800MHz DDR3 ECC Unbuffered memory
• Memory Mirroring supported
Memory Type
• 1333 / 1066 / 800MHz ECC Registered /
ECC Unbuffered
DDR3 SDRAM 72-bit, 240-pin
gold-plated DIMMs
DIMM Sizes
• 1GB, 2GB, 4GB, 8GB• • , 16GB• •
Memory Voltage
• 1.5 V
Error Detection
• Corrects single-bit errors
• Detects double-bit errors
(using ECC memory)
• Supports Intel® x4 and x8 Single Device
Data Correction (SDDC)
On-Board Devices (per Node)
Chipset
• Intel® 5500 (Tylersburg) chipset
• ICH10R + IOH-36D
SATA
• Intel ICH10R SATA 3.0Gbps Controller
• RAID 0, 1 support
IPMI
• Support for Intelligent Platform Management
Interface v.2.0
• IPMI 2.0 with virtual media over
LAN and KVM-over-LAN support
• Winbond® WPCM450 BMC
Network Controllers
• Intel® 82576 Dual-Port Gigabit Ethernet
Controller
• Supports 10BASE-T, 100BASE-TX, and 1000BASE-T,
RJ45 output
• Intel® I/OAT 3 support for fast, scaleable,
and reliable networking
• VMDq support for better performance of
virtualization
• 1x Realtek RTL8201N PHY (dedicated IPMI)
Graphics
• Matrox G200eW 16 MB DDR2
Super I/O
• Winbond W83527HG chip
Clock Generator
• 932S421 chip
Input / Output (per Node)
Serial ATA
• Six Serial ATA ports
• Six SATA hard drives supported
LAN
• 2x RJ45 LAN ports
• 1x RJ45 Dedicated IPMI LAN port
USB
• 2 rear + 1 header (2 Ports)
• 4 total USB ports, 2.0 Compliant / 1.1
Compliant
VGA
• 1x VGA Port
Serial Port
• 1 Fast UART 16550 serial port
System BIOS (per Node)
BIOS Type
• 32Mb SPI Flash EEPROM with AMI® BIOS
BIOS Features
• Plug and Play (PnP)
• PCI 2.2
• ACPI up to 3.0
• USB Keyboard support
|
|
Chassis
Specifications
Chassis
Form Factor
• 1U Rackmount
Dimensions
Height
• 1.7" (43mm)
Width
• 17.2" (437mm)
Depth
• 27.75" (705mm)
Gross Weight
• 40 lbs (18.1kg)
Available Colors
• Black
Front Panel (per Node)
Buttons
• Power On/Off button
• System Reset button
LEDs
• Power LED
• Hard drive activity LED
• 2x Network activity LEDs
• System Overheat LED
Expansion Slots (per Node)
PCI-Express
• 1 (x16) PCI-E ( Low Profile)
Drive Bays (per Node)
Hot-swap
• 2x 3.5" SATA Hot-swap drive bays
SATA Backplane
1U SATA Backplane
System Cooling
Fans
• 6x Cooling Fans
Power Supply
1200W high-efficiency power supply with PMBus
AC Input
• 100 - 140V, 50 - 60Hz, 7.5 - 11Amp
• 180 - 240V, 50 - 60Hz, 5 - 8Amp
DC
Output
+5V standby
• 4 Amp
DC Output +12V
• 74 Amp @ 100-140V
• 100 Amp @ 180-240V
Certification
80 PLUS Gold Certified
Management
Software
• IPMI (Intelligent Platform Management Interface)
v1.5 / 2.0 with KVM support
• Super Doctor III
• Watch Dog
• NMI
Power Configurations
• ACPI Power Management
• Main Switch Override Mechansim
• Power-on mode for AC power recovery
PC Health Monitoring
CPU
• Monitors for CPU Cores,+1.5V, +3.3V,
+5V, +12V, +5 Stdby, +3.3 Stdby, VBAT, Memory
Voltages.
• CPU Core 6-Phase-switching
voltage
regulator
FAN
• Total of four 4-pin PWM fans
• 4x fans with tachometer monitoring
• Status monitor for speed control
• Status monitor for on/off control
• Low noise fan speed control
Temperature
• Monitoring for CPU and chassis environment
• CPU thermal trip support
• Thermal Control for 4x Fan Connectors
• PSU I2C temperature sensing logic
• Thermal Monitor 2 (TM2) support
• PECI
LED
• Power Fail / Overheat LED
• Suspend-state Indicator LED
• UID LED
Other Features
• SDDC Support
Operating Environment / Compliance
RoHS
• RoHS Compliant
Environmental Spec.
• Operating Temperature:
10° to 35° C (50° to 95°F)
• Non-operating Temperature:
-40° to 70° C (-40° to 158° F)
• Operating Relative Humidity:
8% to 90% (non-condensing)
• Non-operating Relative Humidity:
5 to 95% (non-condensing)
|
